Painting your wood stove provides a couple of options in terms of finish.
Can you paint your wood stove.
Use the heat from your stove to cure the paint.
Make sure the paint is well mixed before using with spray cans needing shaken for at least 2 minutes.
Both are used to improve the look of wood stoves and other similar appliances usually cast iron or metal.
Many high heat paints are available with a flat black finish but some also offer paints that dry with a sheen which makes.
Wait about 15 minutes in between the first and second light application of wood stove paint.
They can be applied through wiping them on polish.
Curing occurs when you heat your stove to seal the silicone resin in the paint which is what contains heat resistant properties.
If you want to paint a stove prep the surface by sanding it then use a spray to make sure the stove is free of any debris grease or dust.
Special paints make changing the color of your stove to match a new decor or to conceal damage easy.
Then use an enamel paint which is designed to last longer than other paints.
Allow your wood stove stove pipe or fireplace insert at least 24 hours to air dry after high temp paint application.
Or for paint you simply spray it on.
An average stove uses 2 cans of paint.
For best results high temp paint should be sprayed at a distance of 12 to 18 inches away from the surface.
Be sure the area is well ventilated before applying the paint to your wood stove fireplace fireplace insert or other high temp appliance.
The job does have potential pitfalls however.
Using the wrong paint improperly prepared appliances and bad application techniques will cause the paint to peel.
Turn the heat off and allow the stove to cool.
The better the preparation the better the adhesion.
Two light coats of paint are better than one thick coat.
Instructions for painting and refinishing a wood burning stove using high heat paint.
Wood stove polish and wood stove paint are both helpful products for your stove.
Heat your wood stove to a temperature of 250 degrees f 121 degrees c for 20 minutes.
Adhesion is a function of surface preparation.
There s no quick fix when this happens.